I reassembled my right controller after replacing the joystick then I tested all buttons to see if they click correctly and they do except this stupid menu button. There is a little crack on the shell but I doubt that it's causing problems
also the faceplate is sticking out a little bit despite all the pegs clicking in
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 67
2
If the faceplate is sticking out, I’d take it apart again before forcing anything. That’s probably related to the stuck button.
Check that the menu button is sitting in its little guide properly and that no ribbon cable, rubber membrane, or plastic tab is getting pinched. Also make sure the screws aren’t too tight. A slightly misaligned shell can put pressure on the button and keep it from moving.
That little crack could matter too if it’s letting the shell flex out of position. I’d reseat everything and test the button before fully snapping the controller back together.
crwdns2934105:0crwdne2934105:0
its sitting properly and i can press the button only when the faceplate is off
i dont know how to attach images to comments so i can't show you
ok i noticed that the tighter this crack is pushed in, the harder it is to push the button
crwdns2936751:024crwdne2936751:0 7
crwdns2936753:07crwdne2936753:0 10
crwdns2936753:030crwdne2936753:0 10
crwdns2942667:0crwdne2942667:0 10
