Am I using this program correctly?

Hi so I finally got the analog sticks on my controller these are the Gulikit TMR Joysticks and I dont know whats going out with the right analog stick it clicks, but doesn't register and it looks like it drifts even though they supposed to be new. I tried in BF6 and I don't notice it since I have my dead zone set to 0. Can too much or little solder cause that malfunction?

crwdns2934081:0crwdne2934081:0 crwdns2934083:0crwdne2934083:0 crwdns2934093:0crwdne2934093:0

crwdns2934109:0crwdne2934109:0

crwdns2853045:0crwdne2853045:0 crwdns2853046:0crwdne2853046:0

crwdns2889612:0crwdne2889612:0 0

crwdns2944067:05crwdne2944067:0

Hi!

Can you set us pictures regarding the solder work?

Adding images to an existing question

Thanks!

crwdns2957956:0Dzi 5, 2026crwdnd2957956:0 koppie007 crwdne2957956:0

Hi, I uploaded the photos it starts from the top going clockwise

crwdns2957956:0Dzi 5, 2026crwdnd2957956:0 Christopher D crwdne2957956:0

Hi!

Thanks for the pictures! The pads do look damaged in the 2nd and 3rd photos. Can you remove the solder there and sent a photo again? Is that possible? Thanks!

crwdns2957956:0Dzi 5, 2026crwdnd2957956:0 koppie007 crwdne2957956:0

I will do it as soon as I can

crwdns2957956:0Dzi 5, 2026crwdnd2957956:0 Christopher D crwdne2957956:0

Hi, I uploaded the removed solder from the 2nd photo I did noticed the exposed copper

crwdns2957956:0Dzi 6, 2026crwdnd2957956:0 Christopher D crwdne2957956:0

crwdns2934285:0crwdne2934285:0

crwdns2933313:01crwdne2933313:0