I have a Yihua 8786D rework station and I use Quimtech Liquid No-Clean flux. I have tried everything from minimum airflow to about 50%, and temps up to what it says is 650c and I cannot for the life of me get the m92 chip off of the board. I have tried heating from both above and below the board while properly taping everything off to no avail. Does anyone have any advice?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 36.4crwdns2936485:0crwdne2936485:0
10
24
46
the 8786D only goes to 480c but probably doesnt actually reach that, try putting the airflow to 80
crwdns2934105:0crwdne2934105:0
You led me in the right direction. For some reason beyond me, it's in F and not C, so setting it to 720F did the trick. Thank you for your help!
@qtyler22 no problem
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 23
crwdns2936753:030crwdne2936753:0 23
crwdns2942667:0crwdne2942667:0 23
