Washer stops 2-3 times, all the cycle lights and the warm water flash. If I click the start button twice the machine unlocks and locks and then keeps going. I have already checked the water valves for blockage and used the smart LG diagnostic- nothing is “wrong”.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 553.6crwdns2936485:0crwdne2936485:0
11
426
1.6crwdns2936485:0crwdne2936485:0
Hi @jonthn93783
Go to p.30 in the service manual and run the machine in service mode and check if that shows if anything is wrong.
crwdns2934105:0crwdne2934105:0
The problem has persisted…I have tired to ohm out the water inlet valves (all seem to be fine), the LG app produced an IE error when I conducted the sound test, but verified no kink in water hose or lack of water pressure. The cycle only runs for about 5 minutes…usually after the initial tub is filled with water. Any ideas? I’m not sure a technician can troubleshoot further without replacing random parts?
Just verifying that no errors were shown when running the washing machine in service mode as described in the service manual?
crwdns2934065:0crwdne2934065:0: 7.9crwdns2936485:0crwdne2936485:0
5
6
2
An unbalanced load will give an error and only happens during the spin cycle if it can't rebalance by filling with water. A faulty door switch or loose connector to it, might be causing this.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 2
crwdns2936753:030crwdne2936753:0 26
crwdns2959996:0crwdne2959996:0 234
