Come on guys! it takes few minutes doing this! I say maybe about 10 minutes less or more ....
initially I only taking the LCD part and put a new digitizer on top, but after a while I noticed most of time only the glass part on top of the digitizer layer works and in fact the glass on top is not a part of electronic parts and with a little bit of trick only taking the broken glass on top. glass layer on top is sit on the digitizer pad for better protection and reducing cost of production for digitizer.
Digitizer part is a kind of conductive film which is a bit softer than glass and most of time not broken. the film is a kind of Mika, same as the clear film that used to cover the old kerosine heater. they are very resistance to heat also flexible as well. so when digitizer works and only the glass gone you should take the glass part only, then a $2 glass that sold as protection for LCD on top of the digitizer that even is most cost effective.
you can find the glass only cheaper too ... anyway wasn't sure if this post is real and true or maybe very old and not updated! lol
crwdns2934105:0crwdne2934105:0
crwdns2934113:0crwdne2934113:0
crwdns2915270:0crwdne2915270:0
crwdns2889612:0crwdne2889612:0
0
crwdns2944067:07crwdne2944067:0
did you use a heat gun?
crwdns2934271:0crwdnd2934271:0 James Stoy crwdne2934271:0
heat gun, spatula and whole lotta skill ;)
crwdns2934271:0crwdnd2934271:0 Krayzee crwdne2934271:0
So both Jared and Krayzee got it done? Great job..:-)
crwdns2934271:0crwdnd2934271:0 oldturkey03 crwdne2934271:0
Why would there be scratches on LCD? There is adhesive glue between the Digitizer and LCD protecting the LCD.
crwdns2934271:0crwdnd2934271:0 Brad crwdne2934271:0
Have you done it as well Krayzee?
crwdns2934271:0crwdnd2934271:0 Jared crwdne2934271:0
crwdns2934275:02crwdne2934275:0