crwdns2934065:0crwdne2934065:0: 565
4
1
1
Hello!
I have broken my second Anywhere MX 1 mouse when replacing the SW1. The pad broke again near R6 (signal one, the ground is fine) and I was certain to not break it again. But it happened.
Is there any chance that anyone has got the schema or idea where the signal comes from? I would love to make a jumper and get my favorite mouse to work.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 36crwdns2936485:0crwdne2936485:0
10
23
46
is this copper, can't tell with the flux
crwdns2934105:0crwdne2934105:0
I've edited my post and added photos of front and back. I've checked the C6, which appeared to be connected through a hole, but that side od capacitor appears to be a GND.
Nope - it is a PCB. The pad fell off. The only thing that is copper is the little hair trace that's left.
@makerbuddy have you got a multimeter
Yes I do, so I could tell that the trace goes to ground.
Besides I was working on it and today managed to catch the copper trace that was left from the pad. Used some copper wick as a new pad and everything works fine.
Besides that I still did not got idea where it goes! I've checked every component and signal points, but none of them was giving a beep in continuity test with multimeter...
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 4
crwdns2942667:0crwdne2942667:0 34
