4 
1 Loose connection inside the rectangular rubber-coated case
Where would I start if I wanted to take this apart and re-solder it? Obviously would prefer to avoid any permanent damage. I've tried sliding a knife around the edges (there's a slight ridge where what appears to be two halves were pressed together), but I'm guessing I need heat and/or some kind of solvent. Anyone have experience taking apart weatherproofed / sealed electronics?
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
1
2.4crwdns2936485:0crwdne2936485:0 
crwdns2944067:02crwdne2944067:0
@miketexter post a couple of well -focused images of the "rectangular rubber-coated case" with your Question. that way we can see what you see and hopefully assist you further. Adding images to an existing question
crwdns2934271:0crwdnd2934271:0 oldturkey03 crwdne2934271:0
@oldturkey03 done, thank you for that tutorial :)
crwdns2934271:0crwdnd2934271:0 Mike Texter crwdne2934271:0