crwdns2934065:0crwdne2934065:0: 1
1
Hello,
I get a f06 code on the washer when I run a complete wash cycle. I can usually run a rinse and drain cycle. I read the f06 post and tried unplugging and replugging various connectors on the CCU and MCU. I suspect a failing part, possibly a speed or rotation sensor. Where are these sensors?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 449.6crwdns2936485:0crwdne2936485:0
11
366
1.4crwdns2936485:0crwdne2936485:0
Hi @mron
There is no balance sensor in the washer. At least there's none shown in the parts list for the washer.
Intermittent problems can be hard to find so perhaps try checking the connections between the MCU and the drive motor to see if they're all OK i.e. not loose, corroded etc.
Here's the tech sheet for the washer that may also help. On p.8 it describes how to check the windings for the motor, just in case one winding is not within spec or is on the limit of what may be acceptable to the MCU.
crwdns2934105:0crwdne2934105:0
The tech sheet is very helpful! thanks
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 0
crwdns2942667:0crwdne2942667:0 38
Hi @mron,
What is the model number of the washer?
crwdns2934271:0crwdnd2934271:0 jayeff crwdne2934271:0
It's an elite quiet pack 4
crwdns2934271:0crwdnd2934271:0 Ron Moreland crwdne2934271:0
@mron
The model number would help to ensure that if parts are required that the correct part can be found.
crwdns2934271:0crwdnd2934271:0 jayeff crwdne2934271:0
110 45972400
crwdns2934271:0crwdnd2934271:0 Ron Moreland crwdne2934271:0
110 45972400
crwdns2934271:0crwdnd2934271:0 Ron Moreland crwdne2934271:0
crwdns2934275:04crwdne2934275:0