This is a very specific question, but I hope you can help me out.
I need to figure out what the pinnout of the PSU connector is. The unit itself can be bought, but there are no documents. Also board diagrams are impossible to find.
S/N: ADP-6BF S/ OT9031
https://de.aliexpress.com/item/100500341...
thank you for any help.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 479.6crwdns2936485:0crwdne2936485:0
35
329
971
Have you just probed the board connector to measure things. You basically have two sets of wires for the positive and negative (ground) sides as well as a pair of wires for the power enable.
Using an Ohm meter you should be able to isolate the lines.
crwdns2934105:0crwdne2934105:0
Since the ATV doesn't se over 15 W at peak, I'm converting mine to USB C. Thx for the fast reply. I'm mostly interested in the V coming over each wire, so that I design my usb-c power distribution pcb correctly.
crwdns2936751:024crwdne2936751:0 2
crwdns2936753:07crwdne2936753:0 6
crwdns2936753:030crwdne2936753:0 14
crwdns2942667:0crwdne2942667:0 78
