Major components (bottom cover, battery, wheels, brush assembly) are easy to remove & replace. However, I believe I need to clean connections at the main board below the top cover to repair my Roomba. I don’t see an obvious way to get the cover off. Any help?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 815.7crwdns2936485:0crwdne2936485:0
1.2crwdns2936485:0crwdne2936485:0
923
2.4crwdns2936485:0crwdne2936485:0
@potterra you need to remove the bumper. Then disconnect the ribbon cable from the bumper before you remove it completely. Take a look at this video and use that as a general guide since it is not the same model as yours.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 3
crwdns2936753:07crwdne2936753:0 4
crwdns2936753:030crwdne2936753:0 18
crwdns2942667:0crwdne2942667:0 414
