crwdns2894164:0crwdne2894164:0

Released in 1991, this page relates to the SNS-005 model Super Nintendo controller, released for U.S. markets.

crwdns2886949:01crwdne2886949:0 crwdns2858137:0crwdne2858137:0

Wire Shielding is Pulled out of controller housing

I have a well loved SNES and two original controllers with it, both of which have the shielding of the wires pulled out of the controller shell which I assume just pulled out over time and use. My question is, how is the best way to go about covering the wires again? the best solution I could think of is to buy heat shrink tubing and just ad length to the shielding. But that there also leads to a problem because of the pin connector to the pcb being to large. any ideas or am I over thinking this?

crwdns2893858:0crwdne2893858:0 crwdns2893862:0crwdne2893862:0

crwdns2894050:0crwdne2894050:0

crwdns2889612:0crwdne2889612:0 0
crwdns2892346:0crwdne2892346:0

crwdns2886778:01crwdne2886778:0

Hello, perhaps you can cut two shrink tubes and hold them with zip ties without heating them.

crwdns2894046:0crwdne2894046:0

crwdns2889612:0crwdne2889612:0 0
crwdns2892346:0crwdne2892346:0

crwdns2893896:0crwdne2893896:0

Jon Heliseva crwdns2893898:0crwdne2893898:0
crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 0

crwdns2894768:030crwdne2894768:0 2

crwdns2894770:0crwdne2894770:0 18