I have put the hot air station to 450 degrees and the module will not even budge any idea please i also tryed on the nor but same. The Ps4 was in storage for some time does this effect the solder. there is no way to put quick melt solder on pins as they are under.Any help please
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 50.7crwdns2936485:0crwdne2936485:0
8
14
101
Unless you have the board sitting on a pre-heater 450 degrees would not produce enough heat due to the large ground plain on the PS4. I have never removed one of these IC’s from the PS4 but looking at it I would start my hot air station at 500 and go up from there if needed.
crwdns2934105:0crwdne2934105:0
My hot air station maxes out at 480 unfortunately
Try adding flux to the board near the module. The heat should cause the solder to suck up the flux and become liquidy when hot. Then you can remove it. I got mine to come off at 300 degrees C with a hot air gun. Takes a few minutes.
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 3
crwdns2942667:0crwdne2942667:0 139
crwdns2944067:02crwdne2944067:0
did you put enough flux btw?
crwdns2934271:0crwdnd2934271:0 Augustine crwdne2934271:0
HI Augustine Yes i put but it seems not to go under the chip
crwdns2934271:0crwdnd2934271:0 Kenneth Camilleri crwdne2934271:0