Four slicer failed mid cycle both sides loaded
What component failed to konk out both sides simultaneously Mid cycle?
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
0
650786
crwdns2933313:01crwdne2933313:0
crwdns2934051:0crwdne2934051:0
crwdns2934065:0crwdne2934065:0: 448.9crwdns2936485:0crwdne2936485:0
11
366
1.4crwdns2936485:0crwdne2936485:0
Hi @beaualta ,
Could be any one of several components, thermostat, fuse, switches etc. Anywhere where the power goes through to get to all of the heater elements
Check the control board for any obvious damage i.e. burnt out or heat stressed components etc.
Here’s the ifixit Cuisinart CPT-140BK Circuit Board Replacement guide that should help.
If you spot any damage or even if not, post some close up images back here of the component side of the circuit board. Here’s how to do this Adding images to an existing question
crwdns2930805:0crwdne2930805:0
Adding images to an existing question
crwdns2934079:0crwdne2934079:0
crwdns2937585:0crwdne2937585:0
—
2 - 5 minutes
crwdns2930805:0crwdne2930805:0
Cuisinart CPT-140BK Circuit Board Replacement
crwdns2934079:0crwdne2934079:0
crwdns2937801:0crwdne2937801:0
—
20 minutes
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
0
I’m actually dug into a DeLonghi but think the issue could be universal to any brand. Thanks for the assistance
Thanks @jayeff
