CR1 light turning on and off on control board. Not initiating cycle?

On the back of the circuit board, the CR1 light is blinking as the washer turns on and off. It is a consistent pattern when I plug it in and goes as follows:

*click* CR1 light on for approximately 5 seconds. *click* CR1 light off for approximately 5 seconds. Repeat.

(no lights indicating which step of the cycle washer is in or if lid is locking.) (no lights on front)

I replaced a capacitor which I thought had blown but that did not change anything.

Thanks,

JP

Kenmore Series 100