I have a dual motor lift-board. I’ve had it for a while now but it’s been a since I’ve ridden it. It was good when I was using it. Now I’m trying to start using the board again and it won’t charge. The light keeps blinking red and I don’t know what to do. How do I fix this problem and if I can’t fix it can y’all fix it?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 1,1crwdns2936485:0crwdne2936485:0
5
5
1
Battery could have discharged too far. Recommendation is to get the wheels spinning for 10-15 minutes (they even go as far as saying to be pulled behind on bike) at roughly 10MPH. Check your remote to ensure it gets a little bit of a charge then try charging again.
I'm not sure what type of batteries these run but if they are LiPo, if not stored properly it can cause issues.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 3
crwdns2936753:07crwdne2936753:0 8
crwdns2936753:030crwdne2936753:0 33
crwdns2942667:0crwdne2942667:0 2,262
crwdns2942205:01crwdne2942205:0
Is there a pattern to the blinking? How long has it been plugged in?
crwdns2934271:0crwdnd2934271:0 mayer crwdne2934271:0