Valve carriage replacement installation
I have a new valve carriage replacement part but cannot get it to go in place. Any suggestions?
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
0
502456
crwdns2933313:01crwdne2933313:0
crwdns2934057:0crwdne2934057:0
crwdns2934065:0crwdne2934065:0: 685.3crwdns2936485:0crwdne2936485:0
3.4crwdns2936485:0crwdne2936485:0
1.1crwdns2936485:0crwdne2936485:0
2.6crwdns2936485:0crwdne2936485:0
Here’s a video on how to do it:
https://www.youtube.com/watch?v=MUinUA5g...
also here’s a much more extensive one:
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
1
I appreciate your reply. I'm trying to replace the carriage, that has the circular rubber gasket attached. I found step by step instructions here: http://dysonmedic.co.uk/dyson-dc04-dc07-... if anyone else is looking.
You're my hero. That is exactly what I was looking for, too.
Thanks!
crwdns2942205:01crwdne2942205:0
I have the same problem. Did you figure it out?
crwdns2934271:0crwdnd2934271:0 Matt Ferri crwdne2934271:0