crwdns2934065:0crwdne2934065:0: 1
1
I'm removing the display from the iMac g5's case and using it as a standalone monitor. However, I can't figure out what voltage is being supplied to the inverter from the 6-pin connector on the logic board. Any ideas or pinouts?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 26.3crwdns2936485:0crwdne2936485:0
152
71
50
From the PDF: To start L! inverter one needs 3,3V Run on the fi L n°2 the brown one is connected to the 12V Run and the fi L 3 is connected to the GRD the fi L n°1 (not connected) rule the luminosity and is with 0V.
The PDF is in French you can use Babel Fish or your favorite interpreter for the information you are seeking.
crwdns2934105:0crwdne2934105:0
crwdns2934065:0crwdne2934065:0: 685.3crwdns2936485:0crwdne2936485:0
3.4crwdns2936485:0crwdne2936485:0
1.1crwdns2936485:0crwdne2936485:0
2.6crwdns2936485:0crwdne2936485:0
This answer might be able to help you: Display power inverter pinout or voltage for each of 6 pins needed?
crwdns2934105:0crwdne2934105:0
AB you might want to make this clearer and enter it as an answer. My answer is just a link. Your answer has a lot more info than mine.
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 3
crwdns2942667:0crwdne2942667:0 1,161
