slide out tray that holds printed document
movable tray with a fold up stop to prevent paper from falling onto the floor.
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 2
crwdns2936753:030crwdne2936753:0 14
crwdns2942667:0crwdne2942667:0 89
the two round plastic tabs that hold the movable stop have broken completely off and I need to replace the tray.
crwdns2934271:0crwdnd2934271:0 jhgamble crwdne2934271:0
I am confused with this process. I am in need of a sliding tray that holds the printer document. This tray has a fold up stop to prevent the printed document from landing on the floor. The tabs that permit the fold up stop tab have been completely damaged.
crwdns2934271:0crwdnd2934271:0 jhgamble crwdne2934271:0
It would seem that you will have to replace the Output Paper Catch Tray Assembly, which has the tabs.
I have the same problem and I can’t figure out how to remove the old one.
crwdns2934271:0crwdnd2934271:0 Floridian crwdne2934271:0
I know this is an old thread but I've published a model to MakerWorld that you can print with a 3D printer. Obviously if you don't have access to one there are tons of companies that will print the model on your bahalf. Hope it helps.
https://makerworld.com/en/models/1308242...
crwdns2934271:0crwdnd2934271:0 Andrew Teece crwdne2934271:0