crwdns2934065:0crwdne2934065:0: 349
5
1
I replaced the diode, the driver, and the three capacitors. I had to run a jumper from the diode to the pad under the driver because I lifted the pad. Any ideas why im getting a weak and flickering backlight?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 57,5crwdns2936485:0crwdne2936485:0
18
77
212
Did ya check the filters? Also maybe double check your jump?
crwdns2934105:0crwdne2934105:0
Ill check the filters, but would it work at all if the jumper wasnt connected?
And how should i check the filters? Continuity.. resistance? Im fairly new at this haha
I'm gonna call in the calvalry @refectio
Why did you change the three capacitors?
My first suspicion is a bad connection on the jumper, underneath the driver. You'll also want to check FL2024/FL2025/FL2026. They should measure as a dead short. I would also probe the voltages on the circuit to insure everything is okay.
I changed the three because one of them was short to ground. I dont have the schematic in front of me, but i think we are talking about the same three? What voltage should i be getting?
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 0
crwdns2942667:0crwdne2942667:0 83
