Why washer goes to "ol"during wash/rinse spin
elite,model 110.28032701, after wash no water in tub,clothes still wet,and code"ol"on display
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
1
357127
crwdns2934065:0crwdne2934065:0: 37
1
3
crwdns2933315:02crwdne2933315:0
crwdns2934051:0crwdne2934051:0
crwdns2934065:0crwdne2934065:0: 685,4crwdns2936485:0crwdne2936485:0
3,4crwdns2936485:0crwdne2936485:0
1,1crwdns2936485:0crwdne2936485:0
2,6crwdns2936485:0crwdne2936485:0
See my previous answer on this:
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
1
this answer is for a maytag washer,my question was for a kenmore
It's the same answer. OL is an overload code.
crwdns2934057:0crwdne2934057:0
crwdns2934065:0crwdne2934065:0: 785crwdns2936485:0crwdne2936485:0
1,1crwdns2936485:0crwdne2936485:0
894
2,3crwdns2936485:0crwdne2936485:0
@eddie9115 just checked your washers manual and "oL" still stands for overload. With your washer this could be caused by a bad bearing in the outer tub, a bad control board as well as a bad motor sensor. Check to see if you can ran the diagnostics mode and see what it tells you. Let us know. Kenmore 110 Diagnostics
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
2
