My behringer b212d music cuts off when playing and the volume is set around 1/2 to 2/3? The next day it comes back on. I notice if the volume is set real low the music does not cut off for a long time. I DJ, so I need the speaker to work like it was designed to do.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 785.1crwdns2936485:0crwdne2936485:0
1.1crwdns2936485:0crwdne2936485:0
894
2.3crwdns2936485:0crwdne2936485:0
@jeffburt27 sounds like bad amplifier IC's. Use these guides to disassemble your amp and take a look at the circuit boards. Check the IC's for obvious damage. Post a couple of images of what you see with your question. For that use this guide. That way we can see what you see.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 1
crwdns2936753:07crwdne2936753:0 5
crwdns2936753:030crwdne2936753:0 29
crwdns2942667:0crwdne2942667:0 1,338
crwdns2944067:02crwdne2944067:0
My Beringer speaker keeps going low to high. How do I fix it. I already changed the fuse
crwdns2934271:0crwdnd2934271:0 A Ms Prince crwdne2934271:0
I am experiencing this when I am playing a guitar and vocals through into the mixer. Suddenly my microphone went quiet then didn't have any output at all. I changed the cable and it was louder again. Then on another occasion the same thing happened again. This is a fairly new power amp but the speakers are old. Could it be that the speakers need replaced?
crwdns2934271:0crwdnd2934271:0 William Oke crwdne2934271:0