Hi! My headphones broke on one side. I can see the broken wire inside the ear cup and was wondering if I could just melt the solder that's there and push the wire back in. (after snipping the wire). I've never soldered before and don't know much about electronics.
Here's a picture, you can see where the wire's all broken.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 101,2crwdns2936485:0crwdne2936485:0
8
172
358
Christian, as Shelton stated could be possible, but if you want a good clean trouble free repair at least get a little flux/rosin cored solder so you will have a clean soldered connection, saves from having to do it twice.
A small amount of rosin core solder can be purchased at most electronics stores and big box stores as well.
Below I will post a tutorial on soldering. Good luck.
I hope this helped you out, if so let me know by pressing the helpful button.
crwdns2934105:0crwdne2934105:0
crwdns2934065:0crwdne2934065:0: 385
3
Should be possible, your picture isn't the clearest though. Before of your temp when soldering you don't want to melt anything. Maybe watch a few basic videos on youtube before you try.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 2
crwdns2936753:07crwdne2936753:0 7
crwdns2936753:030crwdne2936753:0 23
crwdns2942667:0crwdne2942667:0 3,240
