crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2861143:0crwdne2861143:0

The iOpener is an insulated, heat-retaining bag that can be heated in a microwave and used to transfer heat to the adhesive along the edge of an iPad or similar device.

crwdns2934591:023crwdne2934591:0 crwdns2934593:0crwdne2934593:0

crwdns2933897:0crwdne2933897:0

Can we use hot water to heat it up?

I don´t own a microwave (but could borrow one from the neighbor).

I do own a Water-heater with thermostat. Could I use that if set to a specific temperature?

What temperature would be right?

crwdns2934089:0crwdne2934089:0 crwdns2934093:0crwdne2934093:0

crwdns2934109:0crwdne2934109:0

crwdns2853045:0crwdne2853045:0 crwdns2853046:0crwdne2853046:0
crwdns2889612:0crwdne2889612:0 1
crwdns2934285:0crwdne2934285:0

crwdns2933313:01crwdne2933313:0

crwdns2934221:0crwdne2934221:0
crwdns2931211:0crwdne2931211:0 crwdns2931215:0crwdne2931215:0 crwdns2934225:0crwdne2934225:0

crwdns2933897:0crwdne2933897:0

Hello Thomas,

We have not done any sort of testing with regards to heating an iOpener in a waterbath, so if you have access to a microwave, it would be your best bet to borrow your neighbor's microwave to do the repair.

- Jasen

crwdns2934105:0crwdne2934105:0

crwdns2853045:0crwdne2853045:0 crwdns2853046:0crwdne2853046:0
crwdns2889612:0crwdne2889612:0 0

crwdns2944067:02crwdne2944067:0:

But in your testing, what temperature did you find to be needed to soften the glue?

crwdns2934271:0crwdnd2934271:0crwdne2934271:0

Jason, do an "iFixit teardown", find out what you are selling. What's in it?

crwdns2934271:0crwdnd2934271:0crwdne2934271:0

crwdns2934285:0crwdne2934285:0

crwdns2934229:0crwdne2934229:0

Thomas Ungricht crwdns2934231:0crwdne2934231:0
crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 0

crwdns2936753:07crwdne2936753:0 0

crwdns2936753:030crwdne2936753:0 2

crwdns2942667:0crwdne2942667:0 522