crwdns2934065:0crwdne2934065:0: 2,4crwdns2936485:0crwdne2936485:0
12
40
2
Replaced screen, now no vibration. The motor doesn't have any kind of cable or flex. Its just soldered. Can someone tell me how to fix this?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 217
4
2
It is usually just the solder that holds it on. You can try to refresh/reheat the solder, but it's going to take a very small soldering iron tip to do that. If the solder joints look good under a magnifying glass, the joints are probably good. You may have to replace that vibrator component. They're fairly common, but I've not heard of any recently that have given out.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 1
crwdns2942667:0crwdne2942667:0 190
