A common issue is not fitting the RAM modules in correctly or fully. I’ve also seen people damage their systems as they didn’t shutdown the system properly and not disconnect the power cord first.
Staying with the original RAM remove them fully and inspect the contact area, is there any visible damage or differences between the Modules? Like maybe something got knocked off.
-
If you don’t see any issues re-insert, firmly press the module in squarely and the. Set the latch bar. Is your system back to the start point? Repeat again this time with the new RAM, but this time only install two, try the top and then the bottom I don’t remember which needs to be loaded first. where you able to get that far? Now install the other two. Are you still working?
+
If you don’t see any issues re-insert, firmly press the module in squarely and the set the latch bar. Is your system back to the start point?
+
+
Repeat again this time with the new RAM, but this time only install two, try the top and then the bottom I don’t remember which needs to be loaded first where you able to get that far? Now install the other two. Are you still working?
A common issue is not fitting the RAM modules in correctly or fully. I’ve also seen people damage their systems as they didn’t shutdown the system properly and not disconnect the power cord first.
Staying with the original RAM remove them fully and inspect the contact area, is there any visible damage or differences between the Modules? Like maybe something got knocked off.
-
If you don’t see any issues re-insert, firmly press the module in squarely and the. Set the latch bar.
+
If you don’t see any issues re-insert, firmly press the module in squarely and the. Set the latch bar. Is your system back to the start point? Repeat again this time with the new RAM, but this time only install two, try the top and then the bottom I don’t remember which needs to be loaded first. where you able to get that far? Now install the other two. Are you still working?
A common issue is not fitting the RAM modules in correctly or fully. I’ve also seen people damage their systems as they didn’t shutdown the system properly and not disconnect the power cord first.
Staying with the original RAM remove them fully and inspect the contact area, is there any visible damage or differences between the Modules? Like maybe something got knocked off.
If you don’t see any issues re-insert, firmly press the module in squarely and the. Set the latch bar.