Ridgid R175RNE Troubleshooting

Nail are firing off target.

The shingle guide is intended to account for sloped work-surfaces. Inaccurate adjustment may do the opposite.

The nosepiece of the nailer should be replaced if it is broken or damaged. See here for a guide.

The nailer is not firing nails.

Make sure you remove any jammed nails. If the nailer continues to jam then adjust the magazine's size offset to the correct one.

Inspect the air supply's PSI setting. Refer to the manufacturer’s specifications for the correct PSI.

Always use the right nails for the job. Low quality nails may not perform to specification as intended by the manufacturer.

The nails will fire but not pierce all the way through.

Inspect the air supply's PSI setting. Refer to the manufacturer’s specifications for the correct PSI. If that doesn't work then try a higher setting.

First, unplug your nailer. Then clean out any accumulated debris in the nail's exit point.

The nailer fires at random times while the button is not being pressed.

Inspect the air supply's PSI setting. It may be too high. Refer to the manufacturer’s specifications for the correct PSI.

Desist in operating the nailer, and remove it from the air supply. Contact the manufacturer of the device and follow the steps they give.

The nailer has been fired and the driver/cylinder will not retract.

Check the nosepiece of the nailer and make sure there that it is clear of any debris.

Try lubricating the nailer. See here for a quick guide.

The nails are bent when they are fired.

The nosepiece of the nailer should be replaced if it is broken or damaged. See here for a guide.

Try lubricating the nailer. See here for a quick guide.

Note: The word "fasteners" may be used in place of "nails" in the manufacturer's documentation. "Nailer" and "nail gun" may be as well.

=== ===