crwdns2933423:0crwdne2933423:0

crwdns2942561:0crwdne2942561:0

crwdns2862678:0crwdne2862678:0

crwdns2895503:0crwdne2895503:0

Protocol Dronium 3x Troubleshooting

Device is Protocol Dronium 3x with Hi-Def Live Streaming Camera

Drone Does Not Lift Off

The drone does not take flight when prompted.

Propellers may be in wrong slots

There are rear and front sets of propellers. If the propellers are put into the wrong part, i.e the rear are placed in the front or vice versa, then they will not allow the device to take off. Check the markings on propellers and make sure they are in right place which may be indicated in manual.

Battery may not be fully charged

Make sure the battery is charged according to the instruction manual. If the battery is fully charged and the drone is still not lifting, replace the battery.

Drone is not turned on

Make sure power switch is turned to ON.

If lights turn on but do not flash, make sure there are no devices synced to the drone.

Can't connect to drone WiFi

Cannot connect phone to drone over its WiFi signal.

WiFi network is not emitted

If your phone is unable to see the Dronium III WiFi, you may need to turn the drone off for one to two minutes and turn it back on. Also close the WiFi tab in your phone and re open it. Then select the Dronium III WiFi when it pops up.

Drone is not turned on

Ensure the drone power switch is set to ON, and all lights are flashing.

Connection is lost

If WiFi connection between the drone and your cellular device is lost, you may need to reconnect to the WiFi. If so, enter your WiFi settings in your phone, and select the Dronium III WiFi. If it is not found, revert to the "WiFi network is not emitted" portion of the guide.

Controls Not Working

Controls on remote do not make drone work.

Device is not connected to controller

To sync controller to the drone

* Turn on the Dronium III.

  • Turn on the controller.
  • Ensure there are no other controllers synced to the drone.
  • Move the Throttle Control stick on the controller to the forward position, then immediately to the back position.
  • Release the Throttle Control stick so that it returns to the center position.

The controller will make a beep sound and the lights will turn solid when sync'ed.

Blades Do Not Spin

The blades do not turn and bring drone into sky.

White toothed housing is out of line of Piston

Unscrew the cap over the rotor in the bottom of the wing (there are four motors, so four caps). There is a little piston that fits into a white toothed housing that spins and turns the bigger wheel. This little white housing may be slightly off the piston so take a screwdriver and push it down back onto the piston.

Drone won't power up

Drone is unresponsive and does not turn on or power up.

Power switch is not turned on

Make sure the power switch is turned to ON.

Battery pack is not connected

If battery pack is not connected or is poorly connected the device will not turn on.

To ensure batter pack is connected

  • Open Dronium III battery compartment.
  • Remove and unplug battery if installed. (If battery pack is not installed skip this step.)
  • Ensure the connection is tight and secure.
  • Insert battery pack into the battery compartment.
  • Close battery compartment.

Preston Ashley

crwdns2935283:009/17/18crwdne2935283:0

101 crwdns2915208:0crwdne2915208:0

crwdns2935297:00crwdne2935297:0

crwdns2915084:0crwdne2915084:0

Washington State, Team S29-G7, Hope Fall 2018 crwdns2935289:0Washington State, Team S29-G7, Hope Fall 2018crwdne2935289:0

WSU-HOPE-F18S29G7

crwdns2931471:03crwdne2931471:0

crwdns2935297:04crwdne2935297:0

crwdns2944067:00crwdne2944067:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 0

crwdns2936753:07crwdne2936753:0 2

crwdns2936753:030crwdne2936753:0 5

crwdns2942667:0crwdne2942667:0 1,773