crwdns2890332:0How do I disassemble the drip stop cup to fix the contact inside?crwdne2890332:0There is a Phillips head screw in the center of the bottom of the drip cup. Remove it, along with the plastic washer and spring. The drip stop assemble then should pop loose with just some slight pressure. Check to see if sensor activation magnet has rusted out (located inside the tall post at the back of the drip stop assembly).
crwdns2890332:0Drip stop light prevents brewingcrwdne2890332:0Our drip stop magnet had also rusted out. Luckily we had a similar style magnet left over from some project in the past. Gently heated the plastic and inserted replacement magnet, then bent the plastic back over the top to retain it in place. Seems to have fixed the problem. Alternate solution is to cut some small pieces off the back of refrigerator magnets and stacking them in the hole where the original magnet rusted away. Update (07/25/2019): Here are some pictures… Remove screw Remove drip stop assembly Magnet (or rust) located inside the tall “finger" (silver spot inside the end of the finger in this photo)