Brent Norris

The laptop just started having vertical lines in the display. I can connect it to an external monitor and that display...

Tcl model 43s525 Tv will turn on and backlights come on, but there is no picture. The power led flashes 2 times every 2...

Toshiba TF-50A810U19 Started off showing colored lines horizontally across the screen. The T-con board was changed, which...

I have a Samsung J3 2016 the display would not come on but you could hear the phone turn on. I replaced the screen and...

I was given an iPhone 6sPlus, The phone restarts at random. It took several tryes to finally get through setting the phone...

Phone will show the Samsung logo then go to the carrier logo and will not load any farther. Factory reset did not resolve...

I change a screen in a customer’s phone everything works fine. Once he removes the Spen and uses it, then puts it back the...

I have repaired many iPhones and several iPhone 8+ but have never came across this situation before. I connected the home...

The usb port is borken on the Lg V40 ThinQ, I tried to charge it with a wireless charger, it stays at 0% and will not...

I have not messed with any cd changers before but I had a customer wanting to know if I could take a look at his player....

You need to do a flashlight test, Turn it on and hold a flashlight up to the screen. If you can see an image then either the power supply board or the backlights are bad. If you see an image then disconnect the cable going from the power supply board to the main board, If the back lights come on then you need to replace the board. If not then its most likely the backlights need replaced.

I hate to be the one that brings the bad news, but if you are able to find a replacement screen for a tv, the cost would be more than what the tv is worth. The screens are the most expensive part of the tv. At this point what I do is take the boards out and try to sale them.

Yes you can replace it with a SSD.

Go to Menu , Picture, Backlight and vary level (0 – 20) • If no backlight changes observed: Check Panel Connector minus (-) pin voltages and P-DIM voltages while changing backlight level. • If minus Panel voltages don’t change, and P-DIM changes, replace SMPS. • If P-DIM doesn’t change replace Main/T-CON Board. MUTE 4 1 9 EXIT to test Panel Backlight Sections.

Not sure how far you are into this, but to remove the heat sink you will see 4 screws around the end of it and 2 screws farther back towards the fan. Those screws will need to be removed. The will also need to be removed as there is a screw under it also that hold it in place.

I had the same issue with a different laptop and a different ssd, I ended up having to connect it to another computer and go so disk management and configure the drive. Once it was done then I installed it in the laptop and was able to install windows on it. Every thing worked fine after that.

Those are standoff screws. If you google M2 Standoff screws you should be able to find some.

Not sure what really happened here but I was getting ready to order a new screen and home button for the phone, The customer was needing their phone back so I Turned on the on screen home button and showed them how to use it. I put the phone back together with the original home button and everything worked just fine.

First check to make sure the cables are connected all the way, Next I would check each cable for the slightest bent connector or tear in the cable. May have to use a magnifing lens, even a slight wrinkle in the cable can cause damage. If you used any heat to separate the screen you may could have damaged the chip connected to the home button.

If this was bought about 1-2 months ago it should still be under warranty. First thing I would do is go to hp support page to see if it can be fixed under warranty before you replace or do anything else with it.