crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Monroe KA Teardown

crwdns2935359:0crwdne2935359:0

  • 1 × Press-to-close Bag, (Many)—For keeping parts safe and separated.
  • 1 × 6-in-1 Screwdriver, (Some), various sizes—You'll use sizes from 1/8" (3 mm) to 3/8" (10 mm).
  • 1 × Large Needle Nose Pliers—The smaller the better.
  • 1 × Probe and Pick Set—For poking and prying at those tricksy little parts.
  • 1 × Penetrating Lubricant—Useful for separating rusted parts. Don't use WD-40, though, it doesn't work as well.
  • 1 × Tweezers
  • 1 × Cleaning rags, (A bunch)
  • 1 × Digital Caliper—For measuring screws.
  • 1 × Arbor Press—To press out taper pins
  • 1 × Heat Gun—To heat up parts connected with taper pins
  • 2 × Pin Punch, 1/16", flat—Used for tapping out taper pins. It's always best to have two, in case one bends.
  • 1 × Hammer—For hitting the pin punch
  • 1 × End mill, 1/16"—For drilling out taper pins if you have to
  • 1 × 64 Bit Driver Kit
crwdns2915442:0crwdne2915442:0

crwdns2918526:0crwdne2918526:0

crwdns2935377:0crwdne2935377:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0