Welcome to my teardown of an Samsung GT-E1205Y!

In this teardown we will take apart an keypad phone without any touchscreen!

Lets take off the back cover shall we?

Inside the back cover we have an 3,7 Volts 800mAh Li-ion battery which is enough for a phone like that.

Looking further we have the following things:

Sim-Card Slot

Battery Pins

Unknown Pins which are labeled with letters?

If we zoom in we can actually see these letters close up, Mine was soldered at B, Everyone might have different soldering

Continuing with the teardown, We will have to unscrew the following screws

PH00 Screws

After unscrewing them, I will make opening with a pick and then continue with a spudger

We are now inside the of the components of the phone! Hooray!!

Now its time to take out the keypad.

Now its time to take out the motherboard...

Lets take a look at the motherboard, At the second image I have labeled what the buttons do.

Looking at the back side of the motherboard we can see the following things

Battery Connector

Sim-Card Slot

Possible chip where the firmware is stored

Headphone and charger connector

Lets look at the shell. We have the following things!

Speaker

Vibrating Motor

Time to take out the speaker!

And now lets take out the vibrating module!

Thats it! We have taken apart the following things!

Keypad

Battery

Speaker and Vibrator

Back and Front Shell

The Motherboard

And the back cover!