crwdns2933423:0crwdne2933423:0

crwdns2942213:0crwdne2942213:0

crwdns2935311:0crwdnd2935311:0crwdne2935311:0 crwdns2935313:0Lost Vape Ursa Nano (1st generation)crwdnd2935313:0crwdnd2935313:0crwdne2935313:0

  1. Lost Vape Ursa Nano (1st generation) Teardown, Peel off sticker where led is located: crwdns2935265:01crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
    • Okay, so basically you have to peel off this sticker (use hair dryer because otherwise you can damage this sticker).

    • Next you have to unscrew two tiny screws to loosen the base and electronics inside

    • Now we start the hardest part. You need to push the electronics out through the USB port located at the bottom, using thin tweezers or a needle. (BE CAREFUL IF YOU USE AN ITEM THAT IS TOO THICK, YOU MAY BREAK THE CHARGING PORT)

    • Congratulations, you've taken apart your inhaler. Now make any necessary repairs and follow the steps in reverse to put it back together

Olivier Pyszka

crwdns2935283:004/14/25crwdne2935283:0

121 crwdns2915208:0crwdne2915208:0

crwdns2935295:0crwdne2935295:0

crwdns2947412:00crwdne2947412:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 8

crwdns2936753:07crwdne2936753:0 33

crwdns2936753:030crwdne2936753:0 125

crwdns2942667:0crwdne2942667:0 143