crwdns2915892:0crwdne2915892:0
Today we are going to be taking apart the Logitech M510 mouse.
crwdns2942213:0crwdne2942213:0
crwdns2936621:0crwdne2936621:0
-
-
Remove the batteries by pulling on the tab.
-
-
-
Take the battery pull tab that is circled in red and tape it to the area that is circled in blue
-
-
-
Unscrew the two screws that are circled in yellow.
-
-
-
-
Now you can easily separate the bottom and the top of the device.(Just give it a little tug)
-
-
-
Okay now that we've got it separated we can have a sneak peek inside
-
The scroll wheel.
-
The battery area
-
Mouse buttons
-
-
-
Now unscrew the screw that is circled in yellow
-
-
-
Now disconnect the cable there is circled in blue by unplugging it from the logic board.
-
-
-
We have taken apart the bottom half, So let's take apart the top half.
-
This is the on-off switch.
-
-
-
Let's get started disassembling the top half
-
Remove the two screws circled in yellow.
-
-
-
Okay now that we've got that done, lets continue
-
-
-
Now you can pop out the scroll buttons.
-
-
-
Now pop out the piece circled in yellow
-
-
-
And there we go we have disassembled the entire mouse.
-
crwdns2947412:05crwdne2947412:0
I’ve actually seen a model of this same mouse where optics sensor is MODULAR with a ribbon cable. So much better for repairability!
I don’t have this mouse, but an LX8 Cordless Laser Mouse. It looked quite similar so gave it a go, and presto! It opened up easily, I could get to all the internal bits quite easily and removed years of cat hair, tobacco grains and human oils which had formed felt mats around the moving parts and gummed it up completely! Now factory fresh and restored to full function - couldn’t be happier! Thanks Xavier!
It says the video is private.
The video is private. But the instructions are good without the video.
Note that the front-side of the mouse has tabs that hold the pieces together, so mate the front of the mouse (the button-side) before mating the end closes to the batteries (and the screws)
Thanks! It would be great if you showed how to take the wheel out - it has to be pried out of its seat in the front of the mouse. FYI for cleaning it only takes steps 1 thru 8 plus taking out the wheel.
