Begin by removing the removable battery.

Use a T10 torx screwdriver to remove the screw.

Then use a prying tool of some sort (Jimmy) to loosen the latches.

Finally, remove it.

Push the tab.

Pull it off.

Use a prying tool to force a gap.

Remove the positive and negative leads of the suction fan from the pcba.

Disconnect the rest of the cables and remove the middle screw.

Once the screw is removed, push the PCBA out. Simply push on the battery connector.

Back up top, pull the 2 top wires through the gap.

You will now have to push the little grey button and the red trigger button in while applying some upwards pressure to loosen the handle.

Now, simply pull the handle out.

Rotate back to the front and remove the 2 marked screws. They're T10 Torx.

She knows you can do it.

To remove the handle chassis, insert a prying tool into the marked gap.

Then, simply apply adequate force in the direction of the arrow.

Now, pull the chassis off, but only enough to expose the pcba and not any more.

Remove the small screw from the PCBA. It is a Torx T6.

Disconnect the cable from the PCBA, then pull the other cables through the gap in the PCBA.

Lead the cable out of the housing as you remove the chassis.

Remove the marked screws, then flip it over.

Unfold the foam filter out of the way, then remove the other 2 screws.

Remove the chassis by bending the transparent plastic out of the way, and unlatching the latches.

Then pull it off.

Remove the 5 screws.

There is still a latch holding it together at the front. Use a prying tool to unlatch it.

Once you remove the suction fan assembly, you can disassemble it by taking these 3 screws off.

All of the screws are sorted by steps and have the sizes written next to them. Use this as a reference during reassembly if needed.