On the backside of the camera, remove the 4.75 mm screw that sits at the top right corner.

Remove the four 4.75 mm screws that sit at the bottom of the camera.

On the side of the camera, remove the two 4.75 mm screws that sit near the USB digital terminal.

On the side of the camera, remove the four 4.75 mm screws that sit near the wrist strap mount.

Remove the two small metal plates, which the four screws hold in place.

Remove the small black plastic piece and set it aside. If necessary, use tweezers to remove the small black plastic piece.

Detach the front case and back case.

Remove the 3.5 mm screw that sits on the metal plate at the bottom of the camera.

Remove the two other 3.5 mm screws that sit on the side, to the left of the screw you just removed.

A ribbon cable attaches to the metal plate and to the main circuit board, on the front of the camera.

Gently release the black latch.

Remove the ribbon cable and metal plate assembly.

On the backside of the camera, remove the 3.5 mm screw that sits to the left of the viewfinder and above the LCD screen.

Remove the second 3.5 mm screw that sits directly above the LCD screen.

Gently detach the ribbon cable.

Locate the ribbon cable on the main circuit board, which sits below the lens.

Gently release the black latch on the ribbon cable connector and detach the ribbon cable.

Remove the LCD screen and set it aside.

On the main circuit board, gently release the black latches of the four ribbon cables.

Gently detach the ribbon cables.

Detach the white-capped and green-capped wires, which sit near the flash.

Using a spudger, gently detach the shutter button assembly from the camera.

Remove the four 3.5 mm screws that hold the main circuit board.

In a hinge-like motion, gently lift the bottom of the main circuit board, which is the side without the soldering points.

Gently detach the white ribbon cable from the underside of the main circuit board.

Gently desolder the two ribbon cables attached to the motherboard.

Remove the motherboard.

Working with the lens-flash assembly, remove the three 3.45mm screws located on the metal plate.

Separate the flash assembly from the lens assembly.

Set aside the flash assembly in a safe location.

Remove the three 2.5mm screws connecting the viewfinder to the rest of the lens assembly.

Remove the three 2.5mm screws underneath the flex circuit.

Remove the small 1.5mm screw attaching the metal plate to the lens assembly.

To reassemble the camera, follow all of the steps in reverse order. Take care to reconnect all ribbon cables and secure screws properly.