crwdns2933423:0crwdne2933423:0

Remplacement du port de chargement du Samsung Galaxy Tab A 10.1

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:01crwdne2931653:0
Samsung Galaxy Tab A 10.1 Charging Port Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Place desoldering braid on one of four holes at top back of motherboard.

  • Place soldering iron on top of the desoldering braid on the gray part of hole to lift solder. If confused here’s a reference.

  • If desoldering braid gets covered with solder and won’t lift anymore, just use a new part of the solder wick.

  • If you're struggling to desolder the charging port, use a heat gun to warm up the entire board. There are a set of tiny square contacts under the charging port that can move around while heating the area. They must be put back if they move.

  • Soldering iron will be very hot and can both burn your hand and possibly damage the device. Lay the motherboard down and do not hold the board while you solder (despite the image.)

Placer la tresse à dessouder sur l'un des quatre trous situés en haut à l'arrière de la carte mère.

Placer le fer à souder sur la tresse à dessouder sur la partie grise du trou pour soulever la soudure. Si confus voici une référence.

Si la tresse à dessouder est couverte de soudure et ne se souleve plus, utilisez une nouvelle partie de la mèche à souder.

Si vous avez du mal à dessouder le port de recharge, utilisez un pistole thermique pour chauffer toute la carte. Il y a un ensemble de petits contacts carrés sous le port de charge qui peuvent bouger si vous chauffez la zone. Ils doivent être remis en place s'ils se déplacent.

Le fer à souder sera très chaud et peut à la fois brûler votre main et éventuellement endommager l'appareil. Posez la carte-mère et ne tenez pas la carte pendant que vous soudez (malgré l'image).

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0