crwdns2933423:0crwdne2933423:0

Shark Rotator Powered Lift-Away Head Nozzle Disassembly

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:06crwdne2931653:0
Shark Rotator Powered Lift-Away Head Nozzle Disassembly: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Shark Rotator Powered Lift-Away Head Nozzle Disassembly: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Remove the 13 screws (circled in yellow) using a phillips screwdriver.

  • Be sure to keep track of which screws go into which hole.

  • Remove the one screw (circled in red) that has a Torx head (might be Phillips head on some models).

  • The Torx screw is hidden under a rubber gasket. Carefully, lift up the gasket without damaging it to access this screw.

  • Remove the horizontal screw (circled in orange) that attaches the gray side panel (necessary to remove the white cap on the roller brush in step 8)

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0