crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Sostituzione scheda grafica iMac Intel 27" (fine 2009 o metà 2010)

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
iMac Intel 27" (Late 2009 or Mid 2010) Graphics Card Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iMac Intel 27" (Late 2009 or Mid 2010) Graphics Card Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

  • Remove the three T9 Torx screws from the graphics card bezel.

  • Locate the large heatsink from the graphics card, which should be right above the optical drive.

  • Remove the single screw holding it in place.

  • Carefully remove the graphics card temperature sensor cable from underneath the motherboard. Exercise caution when pulling it out towards the back/casing, since the cable is very delicate.

  • Remember the position as you need to plug in the new one here. The side with the two metal plates must face upwards.

Rimuovi queste 3 viti Torx T9 dal bordo della scheda grafica.

Individua il grande dissipatore della scheda grafica: dovrebbe essere appena sopra il lettore ottico.

Rimuovi l'unica vite che lo fissa.

Rimuovi delicatamente il cavo del sensore della temperatura da sotto la scheda madre.

Ricordati la posizione del cavo dato che dovrai installare il nuovo nella stessa posizione.

[* red] Remove the three T9 Torx screws from the graphics card bezel.
[* orange] Locate the large heatsink from the graphics card, which should be right above the optical drive.
[* black] Remove the single screw holding it in place.
-[* yellow] Carefully remove the graphics card temperature sensor cable from underneath the motherboard.
-[* icon_reminder] Remember the position as you need to plug in the new one here.
+[* yellow] Carefully remove the graphics card temperature sensor cable from underneath the motherboard. Exercise caution when pulling it out towards the back/casing, since the cable is very delicate.
+[* icon_reminder] Remember the position as you need to plug in the new one here. The side with the two metal plates must face upwards.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0