crwdns2933423:0crwdne2933423:0

Canon EOS Rebel G ロジックボードの交換

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:05crwdne2931653:0
Canon EOS Rebel G Logic Board Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Canon EOS Rebel G Logic Board Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • The large cylindrical object on the right side of the board is the flash capacitor.

  • WARNING: The flash capacitor may carry high voltage, that may persist for hours or even days after the camera has been switched off and/or the battery has been removed.

  • Touching the circuit board while the capacitor still holds its charge may result in a painful electric shock that you will long remember.

  • To make the board safe to work on, short out the two marked terminals with a capacitor discharge tool or the blade of a screwdriver or similar implement (with an insulated handle!) You might have to use moderate pressure to punch through the white goop that covers one of the terminals.

  • There might be little sparks and/or an audible pop. Be careful not to short other solder connections nearby.

  • Use a multimeter to check that dangerous voltage is no longer present before you proceed.

  • Unsolder all of the wires on the top of the logic board.

基板の右側にある大きな円筒形の物体はフラッシュコンデンサです。

警告: フラッシュ コンデンサには高電圧が流れる可能性があり、カメラの電源を切った後やバッテリーを取り外した後でも、数時間、場合によっては数日間電圧が持続する可能性があります。

コンデンサーがまだ電荷を保持している間に回路基板に触れると、長い間記憶に残る痛みを伴う感電を引き起こす可能性があります。

基板を安全に作業できるようにするには、コンデンサ放電ツール、またはドライバーまたは同様の道具 (絶縁されたハンドル付き!) の刃を使用して、マークされた 2 つの端子をショートさせます。 端子の 1 つをカバーします。

小さな火花やポップ音が聞こえる場合があります。 近くの他のはんだ接続をショートさせないように注意してください。

続行する前に、テスターを使用して、危険な電圧が存在していないことを確認してください。

ロジックボードの上部にあるすべてのワイヤのはんだを外します。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0