crwdns2935425:04crwdne2935425:0
crwdns2931653:04crwdne2931653:0
-
Remove the silver casing from the top of the camera. It is loosely clipped in and should come off easily.
-
Using a thin spudger, remove the chrome plastic cover from which the film is ejected. It is clipped onto the main body of the camera, and should come off with a sharp pull.
-
Using a thin spudger, pry off the silver casing from the bottom of the camera.
| - | [* black] Remove the anchors that hold the strap to the body of the camera. There is one on top, and one on the bottom. |
|---|---|
| - | [* black] Use the black spudger to pry off the silver casing on the top and the bottom of the camera. |
| - | [* red] Remove the metal piece from which the film is ejected located on the right side of the camera. There is a 4.75 mm screw under the metal piece. Use a Phillips #000 screw driver to remove it. |
| + | [* black] Remove the silver casing from the top of the camera. It is loosely clipped in and should come off easily. |
| + | [* black] Using a thin spudger, remove the chrome plastic cover from which the film is ejected. It is clipped onto the main body of the camera, and should come off with a sharp pull. |
| + | [* black] Using a thin spudger, pry off the silver casing from the bottom of the camera. |
| + | [* icon_caution] The bottom silver casing is clipped on tightly around the film ejection area, but is not held on by any screws or glue. Make sure to unclip it fully (this may take some force) before removing it, to avoid breaking it. |
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0