Head Cleaning V4/V5

crwdns2936071:01crwdne2936071:0 — Setting the printer

With the printer powered on, enter the menu screen and select the "Config. Rápida" (Quick Setup) option.

crwdns2936071:02crwdne2936071:0 — Repositioning the table

When the table is in the position shown in the photo, press the Reset button on the left side of the machine, as shown.

crwdns2936071:03crwdne2936071:0 — Repositioning the head

With the table in place, manually push the head to the center of the machine for easier handling.

crwdns2936071:04crwdne2936071:0 — Removing the nozzle

Position the 20mm Fork Spanner, as shown in the figure, locking the inside of the head in order to prevent the nozzle from spinning.

crwdns2936071:05crwdne2936071:0 — Removing the top PTFE

With your hands, pull the PTFE tube from the head, pressing the black part of the piece where the tube is fitted.

crwdns2936071:06crwdne2936071:0 — Removing the inner PTFE

Positioning the bit in the indicated hole, push it down until the inner PTFE comes out from under the head (where the nozzle hole is).

crwdns2936071:07crwdne2936071:0 — Replacement and Cleaning

Finish removing the internal PTFE and replace it with a new one or clean it.

crwdns2936071:08crwdne2936071:0 — Reassembling the head

Replace the nozzle at the bottom of the head and the PTFE at the top, pushing it all the way down with your hands.

crwdns2936071:09crwdne2936071:0 — Returning the table to the initial position

Reposition the table, in the option "Home XYZ" of the menu, in the section of quick setup and wait for it to be in the position indicated by the figure