crwdns2933423:0crwdne2933423:0

Remplacement du panneau lumineux LED IR du AvertX HD810

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:01crwdne2931653:0
AvertX HD810 IR LED Lightboard Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 AvertX HD810 IR LED Lightboard Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 AvertX HD810 IR LED Lightboard Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Use the PH1 screwdriver to remove or loosen both 10mm screws on either side of the inner protective lens cover. This will loosen both the cover and the IR LED lightboard.

  • The cover and the lightboard are two separate pieces held in place by these two screws. The cover should be set aside first before continuing with the lightboard.

Utilisez le tournevis PH1 pour retirer ou desserrer les deux vis de 10 mm de chaque côté du couvercle de protection interne de la lentille. Cela desserrera à la fois le couvercle et le panneau lumineux LED IR.

Le couvercle et le lightboard sont deux pièces séparées maintenues en place par ces deux vis. Le couvercle doit être mis de côté avant de continuer avec le lightboard.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0