crwdns2933423:0crwdne2933423:0

iPod Nano 1. Generation Akku Austausch

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:04crwdne2931653:0
iPod Nano 1st Generation Battery Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iPod Nano 1st Generation Battery Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • To aid in soldering the new battery, be sure the solder pad holes are clear of solder. This way, you can insert the new battery leads and solder them in place.

  • To open the solder holes, open a safety pin and push it against the solder blocking the hole. At the same time, heat the same solder pad from the other side of the logic board. Opening the holes completely will require repeating this procedure several times from alternating sides of the logic board.

  • These holes are extremely small, so the safety pin will probably be too large to pass all the way through. Do not insert the entire pin through the hole -- only the tip of the pin.

  • You can also try entering the tip of the pin on the other side of the board to open the solder pad hole.

Um das Löten des neuen Akkus zu erleichtern, stelle sicher, dass die Lötstellen frei von Lötzinn sind. So kann man die neuen Kabel in die Löcher stecken und sie anlöten.

Um die Lötstellen zu öffnen, öffne eine Sicherheitsnadel und drücke sie gegen den Lötzinn, der das Loch blockiert. Zur gleichen Zeit, erhitze die gleiche Stelle von der anderen Seite des Logic Boards. Um die Löcher komplett frei zu bekommen, muss diese Technik mehrfach von beiden Seiten des Boards angewandt werden.

Diese Löcher sind sehr klein, sodass die Sicherheitsnadel wahrscheinlich zu groß sein wird, um komplett durch das Loch zu passen. Stecke nicht die ganze Nadel durch das Loch, nur die Spitze.

Man kann auch versuchen die Spitze der Nadel von der anderen Seite des Boards durch das Löt-Loch durchzustechen.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0