crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

LG G3 Bildschirm flackert und verblasst

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
    1* Take# Remove the battery out.

    2*Unscrew# Unfasten all screws and remove the whole backplastic cover.

    3*# You will see a connector down atconnectors next to the chargercharging port take. Disconnect them off and you can blow some air to take the dirt off.

    4*# Take some paper and fold it 4 to 6 times (small one).

    5*# After folding it make sure it is the size of the connector that is next to the Camera.

    6*# Place the foldenfolded paper on top of the connector.

    7*# Slowly get back all the plastic covers.

    8*Screw# Put all screws back in all the screwsand fasten them.

    9*# Place the battery, SD Card and the Sim back.

    10*# Power on the Phone.
    99.9% It will work.
    UPDATE:
    If you want to take it a step further,

     get some thermal paste

     and remove the whole circuit board and put some on the spot (as shown in the picture) do NOT put too much a dot will be enough...
    after that, you can go ahead and place the circuit board back in place, then place the paper on the connector(follow the steps 6-10)
    *Even thermal pad might do the job.
    Thanks,
    I hope this will fix the problem !

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0 — Platziere das gefaltete Papier hier!

      Platziere das Papier hier auf diesen Anschluss!

      crwdns2936071:02crwdne2936071:0 — Wärmeleitpaste

      Ein kleiner Punkt mit Wärmeleitpaste bringt mehr als eine größere Menge!

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0