Renew Kärcher K3.68 MD E-Kasten

crwdns2936071:01crwdne2936071:0 — Remove handle element

First, the detergent dispenser must be removed, to the hose at the marked position must be removed, turn the container by slightly be removed. Remove the handle Assembly to the markedcross-head screws must be unscrewed, then the handle element can be pulled off to the front.

crwdns2936071:02crwdne2936071:0 — Remove bumper

Remove the four marked Torx TX16 screws, then remove the screws from the small side cover. The small lid can be removed then sideways. He is fitted on one side, this is done the bumper can be removed.

crwdns2936071:03crwdne2936071:0 — Remove yellow Front Cap

To disassemble the yellow front hood 6 cross head screws must be removed on the back. Also at the bottom, in the middle and on top. To reach the middle screws a 110 mm long screwdriver is necessarry. Turn the device and the yellow lid can be removed .

crwdns2936071:04crwdne2936071:0 — Remove the motor unit

Unsrew the Screws of the motor holder flange and remove the flange, then the strain relief of the cable from the mounting brackets side out, so that the engine is now freely be removed

crwdns2936071:05crwdne2936071:0 — Remove the water connectors

Remove the securing clips to remove the suction connection and the connection of the pressure side, then the ports can be situated. The inlet side goes out somewhat hard, there must be a little.

crwdns2936071:06crwdne2936071:0 — Building a holder for GeradSschubführung

This step is important because, if the top metal bracket is removed without backup, the whole pressure springs of the thrust management come out and it will be very difficult to get them back together. I've taken long two screw clamps holding together the lower straight thrust Guide

crwdns2936071:07crwdne2936071:0 — Remove the control box

Loos the four 6 mm Allen bolts and remove the metal lid, then the head carefully remove because among them are also feathers. If necessary also the seal (90814220) can be changed in this context

crwdns2936071:08crwdne2936071:0 — Refer to E box

The E-box can now be pulled off upwards. The protective earth conductor must be unscrewed from the housing. You can disassemble the E box also by pushing on the clip mounts and the hood then away, how to get on the inside. The E-box comes just completely, so that it can then be replaced