Reely Carbon Fighter Brushless Motorritzel Replacement

crwdns2936071:01crwdne2936071:0

If there is an additional main sprocket and engine sprocket protection (not serial condition), this must be removed first. To do this, all marked screws must be turned out with a PH1 screwdriver. These are two different screws.

crwdns2936071:02crwdne2936071:0

Then remove the red marked screw (PH1) on the underside (hold the green marked part),

crwdns2936071:03crwdne2936071:0

To loosen the pinion, the grub screw that fixes it to the motor output shaft must be loosened. For this you need a 1.5mm Imbus.

crwdns2936071:04crwdne2936071:0

When pushing the new part onto the shaft, please note that it has a flattened side. At this the grub screw (marked in green) should rest.

crwdns2936071:05crwdne2936071:0

Then the distance of the two gears to each other should be adjusted correctly. Too big a game makes sure that the teeth consume early, with too little play it can not be turned anymore.