crwdns2933423:0crwdne2933423:0

Replace Kärcher RC3000 brush motor. replacement

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0

      Remove both batteries.

      crwdns2936071:02crwdne2936071:0

      Remove protective rubber collision protection and cover.

      crwdns2936071:03crwdne2936071:0

      Unplug the on/off switch.

      crwdns2936071:04crwdne2936071:0

      remove pins. Caution, risk of injury for the inexperienced.

      crwdns2936071:05crwdne2936071:0

      Detach outer upper case (do not remove yet!). To do this, loosen 4 screws. With slotted screwdriver or 8 Torx.

      crwdns2936071:06crwdne2936071:0

      rotate device. Hold both frames. Be careful, the screws will fall out. 4 left?

      crwdns2936071:07crwdne2936071:0

      Disconnect the brush motor connector.

      crwdns2936071:08crwdne2936071:0

      Remove brush motor.

      crwdns2936071:09crwdne2936071:0

      Install new brush motor.

      crwdns2936071:010crwdne2936071:0

      plug in.

      crwdns2936071:011crwdne2936071:0

      ...put on more plugs.

      crwdns2936071:012crwdne2936071:0

      Check the sensors for correct seating

      crwdns2936071:013crwdne2936071:0

      The pins that must hold the spring must dip into the opposite frame part.

      crwdns2936071:014crwdne2936071:0

      Reinsert the pins for the brush from the correct side.

      crwdns2936071:015crwdne2936071:0

      Insert pins to the end.

      crwdns2936071:016crwdne2936071:0

      Install brush

      crwdns2936071:017crwdne2936071:0

      Plug in the connector for the charging contacts

      crwdns2936071:018crwdne2936071:0

      Mount the yellow cover

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0