crwdns2933423:0crwdne2933423:0

Hoe moet je (de-)solderen?

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:05crwdne2931653:0
How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Thread the component leads through the circuit board holes. Most components should lie flat, close to the board.

  • Double-check the orientation if the component is electrically directional (such as diodes, LEDs, and electrolytic capacitors).

  • Diodes normally have a bar indicating the cathode (-). LEDs have a shorter lead on the cathode (-) and a flat spot on the dome.

Plaats de uiteinden van het onderdeel dat je wilt solderen door de gaten in de prinplaat. De meeste onderdelen moeten plat op de printplaat komen te liggen.

Controleer de positie van het onderdeel als het een onderdeel is dat elektriciteit maar een kant op geleidt (zoals diodes, LED's en elektrolytische condensatoren).

Diodes hebben normaal gesproken een streepje die de cathode (-) aangeeft. LED's hebben vaakt een korte uiteinden als cathode (-) en een platte plek op de bolle kant.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0