如何焊接和拆焊

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935425:018crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:018crwdne2931653:0

Use tweezers to grip the component and remove it.
If the leads are stuck but don't have a lot of residual solder, heat the solder pad directly and use tweezers or a spudger to gently remove it.
If there is still a lot of solder left on the pad, apply more flux and try using the wick again.
Use flush cutters to remove your used wick.
When you're done desoldering, refer to this step to clean up your board.

使用镊子夹住组件并将其取出。
如果引线卡住了但没有太多残留焊料，则直接加热焊盘，然后用镊子或撬棒轻轻将其取出。
如果焊盘上仍残留大量焊料，请涂抹更多助焊剂，然后尝试再次使用焊芯。
使用平切钳取出用过的灯芯。
拆焊完成后，请参考此步骤清理您的电路板。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0