crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

연결부 납땜 및 납제거 방법

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:018crwdne2931653:0
How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

  • Use tweezers to grip the component and remove it.

  • If the leads are stuck but don't have a lot of residual solder, heat the solder pad directly and use tweezers or a spudger to gently remove it.

  • If there is still a lot of solder left on the pad, apply more flux and try using the wick again.

  • Use flush cutters to remove your used wick.

  • When you're done desoldering, refer to this step to clean up your board.

핀셋을 사용하여 부품들을 집어서 분리하세요.

리드가 붙어 있지만 잔류 납땜이 많지 않은 경우 납땜 패드를 직접 가열하고 핀셋이나 스퍼저를 사용하여 살살 분리하세요.

패드에 여전히 납땜이 많이 남아 있으면 플럭스를 더 바르고 심지를 다시 사용해 보세요.

사용한 심지를 분리하기 위해 플러시 커터를 사용하세요.

납제거가 끝나면 이 단계를 참조하여 보드를 청소하세요.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0